MIMO Junior MMJ543
(NetPassage WPP543) is a high-performance Indoor/Outdoor Access Point with integrated PoE.

Using Atheros AR7130 (300MHz) Processor, WPP543 is able to
support high-speed data transmission of up to 54Mbps, 108 Mbps or
300Mbps.
MIMO Junior MMJ543 is embedded with an integrated directional
dualpolarization (vertical and horizontal) antenna, supporting 2.4 GHz or 5GHz
(8dBi for 2.4GHz and 13dBi for 5GHz), or other depending on order configurations. Dual-polarization antenna provides good diversity coverage and better noise immunity.

It has integrated high power radio, coupled with firmware
which support multiple SSID, long range support to allow for higher throughput,
wider coverage.
The device is a powerful and yet easy to use and implement for wireless ISP

Features
*-Atheros eXtended Range
technology
*-300Mhz, 16MB SDRAM, 4MB Flash
*-1x Compex WLM200NX-20
20dbi MiniPCI card pre-installed

*-Built-in internal
high sensitivity dual-polarization antenna
, 8dbi for 2.4GHz band or 13dBi for 5GHz
band
*- Spare external
antennae connector
*-Support
Power-over-Ethernet
(PoE passive)
*-Supports
64/128-bit WPA, WEP, TKIP, AES,
IEEE802.1x authentication
*-Embedded NOR flash, and
support NAND flash memory expansion
*-Antenna
Alignment
*-Build in with Grounding Terminal
*-Surge arrestor
support
*-Weatherproof casing

Multiple SSID  
• Supports up to 4 virtual
access points (VAP) per radio (concurrent dual band possible),
with unique BSSIDs. Traffic from each VAP can be tagged to a unique VLAN and /or
bridged if required. Each VAP will be able to configure their own security (WPA,
WEP, TKIP, and AES).

 
Long Range Support
• Suitable for long-range wireless deployment with
Proprietary Long Distance Algorithm for ACK and CTS timeout adjustment support. 
• Provides recommended values
for the parameters and at the same time allow for manual fine-tuning for optimal
performance. 
 
Antenna Alignment
•
Antenna Alignment feature allows the system integrator to align the antenna for
best signal strength.
 
 
FIRMWARE INFORMATION

 Operating Modes 
 • Access Points
 •
Client
 • RootAP / Transparent Client (Work in Progress, FW upgrades)
 • Repeater (Work in
Progress, FW upgrades)
 • Wireless Adapter (Work in Progress, FW upgrades) 

 • Wireless Routing Client (Work in Progress, FW upgrades) 
 • Gateway

 WAN Type 
 • Static IP
 •
Dynamic IP
 • PPPoE
 • PPTP
 • L2TP

 Device Management 
 • HTTP / HTTPs Web
Server
 • SNMP V2c
 • Telnet / Secure Shell (SSH)

 Data Capture & Notification 
  •
Event Login (Syslog)
 • Detailed Statistics per Client

 Virtual Access Point (VAP) 
 • Up to 4
SSIDs with unique MAC Addresses (BSSID)
 • 802.1q VLAN tag per VAP with
Bridging
 • Configurable Security (WPA, WEP, TKIP, AES, MAC Filtering) per
VAP
 Advanced Features 
 • Built-in DHCP
server
 • Transmission Power Control (One dB per step)(Work in
Progress)
 • Closed System (Suppress SSID)
 • Transmission
Rate Control
 • Spanning Tree Protocol

• Suitable for Long Range wireless deployment with high
  receiver 
   sensitivity. 
  
• Ideal as CPE device connecting PtP with a
  central AP
  
• Device power from PoE through ethernet cable provide
  flexible installation.
  
• IEEE 802.11h (DFS & TPC) 
  
• Enables worldwide operation through support for
  standards-based  
  
• Dynamic Frequency Selection (DFS) and Transmission
  Power Control (TPC) 
  
• SNMP Traps enable an agent to notify the management
  station of significant events by way of
  an unsolicited event.
  
• Antenna Alignment  Allows user to adjust their external antenna to
  receive the optimum throughput.
  
• DHCP Relay
  (Only in Gateway or Wireless Routing Client Mode)  Allows DHCP Clients on
  different subnets to get IP address from  central DHCP server.
  
• Remote Upgrade of Firmware  Allows user to upgrade
  their firmware through Telnet/SSH
  Parallel Bandwidth l(Only in Routing
  Mode)  Provide scalable Internet bandwidth with Load Balancing and
  Fail-Over Redundancy.
  
• RIP 1 / 2 (Only in Gateway or Wireless Routing Client Mode)  Routing
  Information Protocol Version  1 /
  2 
   
   
  CUSTOMIZABLE
  FEATURES 
  Interface
  Customization  / No Label or Customized logo
  for OEM customers. 
  Contact OxfordTEC Volume Sales for further
  configurations and price breaks